|
|
Zeile 12: |
Zeile 12: |
| make | | make |
| | | |
− | * Script zur Erstellung von GCode aus Eagle-Files [[media:pcbcam]]
| + | Vorsicht, pcb2gcode rechnet alles in Inches! |
| + | |
| + | ==== Script zur Erstellung von GCode aus Eagle-Files [[media:pcbcam.gz]] ==== |
| + | |
| + | Das Skript erzeugt aus einem Eagle-Board-File (Endung .brd) mehrere G-Code-Files und Postscript-Files für die Erstellung der Lötstoppmaske. Die erzeugten Dateien sind im Einzelnen: |
| + | |
| + | ; back.ngc : Lötseite |
| + | ; front.ngc : Bestückungsseite |
| + | ; outline.ngc : Ausfräsung der Platine |
| + | ; drill.ngc : Bohrungen |
| + | ; back_stop.ps : Lötstoppmaske Lötseite |
| + | ; front_stop.ps : Lötstoppmaske Bestückungsseite |
Version vom 24. Juli 2011, 07:10 Uhr
* http://www.carbide-tools.com/knowHow.htmld/
Eagle nach G-Code
sudo aptitude install build-essential autoconf libtool gerbv libboost-dev libboost-program-options-dev libglibmm-2.4-dev libgtkmm-2.4-dev
git clone git://pcb2gcode.git.sourceforge.net/gitroot/pcb2gcode/pcb2gcode
cd pcb2gcode
autoreconf
./configure
make
Vorsicht, pcb2gcode rechnet alles in Inches!
Script zur Erstellung von GCode aus Eagle-Files media:pcbcam.gz
Das Skript erzeugt aus einem Eagle-Board-File (Endung .brd) mehrere G-Code-Files und Postscript-Files für die Erstellung der Lötstoppmaske. Die erzeugten Dateien sind im Einzelnen:
- back.ngc
- Lötseite
- front.ngc
- Bestückungsseite
- outline.ngc
- Ausfräsung der Platine
- drill.ngc
- Bohrungen
- back_stop.ps
- Lötstoppmaske Lötseite
- front_stop.ps
- Lötstoppmaske Bestückungsseite